Table 94, Vehicle Adapter Or Control Module Parameters And Defaults - TrimTrac ProE Locator Technical Manual

Vehicle Adapter or Control Module Parameter Ranges and Default Settings
Parameter
HPA Idle Timeout, T11
MPA Idle Timeout, T12
HPA Delay Timeout, T13
MPA Delay Timeout, T14
HPA Transmit Timeout, T15
MPA Transmit Timeout, T16
HPA Query Timeout, T17
HPA Transmit Attempts, N5
MPA Transmit Attempts, N6
LPA Transmit Attempts, N7
HPA Mode
MPA Mode
LPA Mode

Table 94, Vehicle Adapter or Control Module Parameters and Defaults.

Unit/Notes
In Seconds (10-999990)
In Seconds (10-999990)
In Seconds (10-86400)
In Seconds (10-86400)
0=Infinity; Else in Seconds (10-999990)
0=Infinity; Else in Seconds (10-999990) If not set
0-Infinity, should be set no lower than 300
Seconds.
In Seconds (10-3600)
0=Until T15 Expires; 1-255=Number of Tx
Attempts before T15 expires
0=Until T16 Expires; 1-255=Number of Tx
Attempts before T16 expires
0=Until T3 Expires; 1-255=Number of Tx Attempts
before T3 expires
0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only
0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only.
WARNING: Before inserting a Vehicle Adapter
or Control Module:
A) Connect the red (+) and black (-) wires to a
9-32 VDC power source and install a 100k Ohm
resistor across the yellow wires; OR
B) Return MPA Mode to its default setting
"1=Disabled".
0=Automatic; 1=Disabled; 2=Network
Acknowledgement; 3= Monitor-only (regardless of
motion)
Default Messages Commands
10
10
10
10
0
300
60
0
>STKY
0
>QKTY AT+CTKY
>RTKY
0
0
1
0
TrimTrac ProE Locator Technical Manual v2.0e 193