Table 58, Set_App_Config Message - TrimTrac ProE Locator Technical Manual

SET_APP_CONFIG
The SET_APP_CONFIG message is used by the server application to set the
primary state machine parameters in the TrimTrac ProE. When received the
TrimTrac ProE will send a RESP_APP_CONFIG (page 170) message in
response.
>STKABBBBBBCCCCCCDDDDDDEEEEEEFFFFFFGGGTTHIJK;PW=PPPPPPP
P;ID=YYYYYYYY;*ZZ<
A
TrimTrac Configuration Set:
BBBBBB
IDLE Timeout, T1
CCCCCC
FIX Timeout, T2
DDDDDD
TRANSMIT Timeout, T3
recommended. Default 300
EEEEEE
DELAY Timeout, T4
FFFFFF
QUERY Timeout, T5
GGG
Almanac Timeout, T6
TT
Static Motion Filter Timeout, T7
used exclusively
the Dynamic Motion Filter
is:
A.
B. Set "1-Duty-Cycled"
running.
Always
to Static Motion Filter Counter, N3. Default 20
H
Motion Report Flag
1=Start Motion Report
2=Stop Motion Report
Start & Stop Motion Reports. Default 0
3=
I
Report Delay Flag
1=Tx Exception Reports & Query/Set
2=Tx Motion-related, Exceptions &
3=Tx IDLE Timeout, T1, Status Msgs, Exceptions
4=Tx Start/Stop, IDLE
5=Tx every 6th motion-triggered message, Exceptions &
6=Tx every 11th motion-triggered message, Exceptions & Respones
7=Tx Start/Stop, Exception & Responses (No IDLE Status)
J
Diagnostics Mode
K
Communication Mode
Default 0
PPPPPPPP
Security Password
ONLY.
YYYYYYYY Unit ID. Always 8 alphanumeric characters, UPPER CASE ONLY
ZZ
Checksum.

Table 58, SET_APP_CONFIG Message

.
In seconds (10 – 999990)
.
In seconds (10 – 3600)
.
.
In seconds (10 – 86400)
.
In seconds (10 – 3600)
.
In hours (10 – 990)
while in the IDLE
Timeout, T21, whenever Anytime Polling
Set "2=Anytime OnDemand";
and Polling Duty-Cycle On-Time, T20, is
set Static Motion Filter Timeout, T7, greater than or equal
.
0=None
.
0=Transmit ("Tx") All Messages
Status, Exceptions & Responses
.
0= None; 1= LED
.
0= SMS; 1= GPRS; 2=AutoSelect
.
Always 8 alphanumeric characters, UPPER CASE
Default 00000000
TrimTrac ProE Locator Technical Manual v2.0e 148
'A' = Application Parameters
. Default 43200
. Default 300
Less than 300 not
In seconds (10 – 3600)
. Default 900
. Default 60
. Default 168
.
In seconds (0 – 90). Note: T7 is
however, it is superseded
state;
OR
Responses only
Responses
& Responses
. Default 1
by
Respones
. Default 0
.