Provisioning At Commands; Table 28, Summary Of At Commands - TrimTrac ProE Locator Technical Manual

Provisioning AT Commands

AT Command Summary
The following AT commands are used to provision and configure the TrimTrac
ProE via HyperTerminal when connected to the Provisioning Module.
Command
AT+CTKC
AT+CTKC? Queries Application parameters
AT+CTKE
AT+CTKF
AT+CTKF? Queries GPRS Connection parameters
AT+CTKJ
AT+CTKJ? Queries GPRS Setup parameters
AT+CTKG
AT+CTKG? Queries GPS parameters
AT+CTKK
AT+CTKK? Queries Geofence parameters
AT+CTKP
AT+CTKP? Queries SMS Communication parameters
AT+CTKX
AT+CTKX? Queries Extended Application parameters
AT+CTKY
AT+CTKY? Queries Vehicle Adapter and Control Module
AT+CTKZ
AT+CTKZ? Queries Extended 2 Application parameters
AT+CTKO? Retrieves Logged Messages
ATI

Table 28, Summary of AT Commands

Description
Assigns Application parameters
Restores Factory Defaults and/or Erases Message Log
Assigns GPRS Connection parameters
Assigns GPRS Setup parameters
Assigns GPS parameters
Assigns Geofence parameters
Assigns SMS Communication parameters
Assigns Extended Application parameters
Assign Vehicle Adapter and Control Module
parameters
parameters
Assigns Extended 2 Application parameters
Queries Firmware Version
TrimTrac ProE Locator Technical Manual v2.0e 116
See Page
117
119
119
121
122
123
125
127
131
134
125
136