TrimTrac ProE Locator Technical Manual page 209

Parameter Unit/Notes
Query Hold Flag 0=Disabled; 1=Enabled. Note: Unit attempts to reconnect to
the GSM network if the connection is lost during the
QUERY state prior to the expiration of QUERY Timeout,
T5.
Reserved 0=Formerly "Extended Motion Detection" in TrimTrac 1.0
Not used in TrimTrac ProE.
Position Report 0=Until T3 Expires; 1-255=Number of Tx Attempts. Set to 1
Transmit Attempts, N1 if Communication Mode set "1=GPRS-only"
Status Message 0=Until T3 Expires; 1-255=Number of Tx Attempts. Set to 1
Transmit Attempts, N2 if Communication Mode set "1=GPRS-only"
Static Motion Filter In Seconds (1-90). Note: This parameter is used only while
Counter, N3 Static Motion Filter Timeout, T7, is running in the IDLE
State. It is superseded by the Dynamic Motion Filter
Counter, N4 whenever:
A. Anytime Polling is set "2=Anytime OnDemand"; OR
B. Polling Duty-Cycle On-Time, T20, is running due to
Anytime Polling being set "1=Duty-Cycled".
Always set Static Motion Filter Counter, N3, equal to or less
than Static Motion Filter Timeout, T7.
Dynamic Motion Filter In Seconds (1-90). Note: T21 applies in TRANSMIT,
Timeout, T21 QUERY and DELAY States. Also applies in IDLE if:
A. Anytime Polling is set "2=Anytime OnDemand"; OR
B. Polling Duty-Cycle On-Time, T20, is running due to
Anytime Polling being set "1=Duty-Cycled".
WARNING: Dynamic Motion Filter Timeout, T21, must
always be set equal to or greater than Dynamic Motion Filter
Counter, N4; else the unit may not exit QUERY state.
Default Messages Commands
0
0
1
1
>STKX
>QTKX AT+CKTX
10
>RTKX
20
TrimTrac ProE Locator Technical Manual v2.0e 191