Table 30, At+Ctkc? Query - TrimTrac ProE Locator Technical Manual

Default: AT+CTKC=43200
AT+CTKC?
+CTKC: <
IDLE Timeout, T1
>,<
T3 DELAY Timeout, T4
Motion Filter Timeout, T7
>,<
Mode Communication Mode
OK
T1
<IDLE Timeout, >
T2
<FIX Timeout, >
<TRANSMIT Timeout,
T3
>
T4
<DELAY Timeout, >
T5
<QUERY Timeout, >
T6
<Almanac Timeout,
Filter
<Static Motion
Timeout, T7
>
<Motion Report Flag>
<Report Delay Flag>
<Diagnostics Mode>
<Communication
Mode>

Table 30, AT+CTKC? Query

300 300 900 60
, , , ,
>,<
FIX Timeout, T2
>,<
QUERY Timeout, T5
>,<
Motion Report Flag
>
In seconds (10 – 999990). Default
In seconds (10 – 3600). Default
In seconds (10 – 3600)
300
Default
In seconds (10 – 86400). Default
In seconds (10 – 3600). Default
> In hours (10 – 990). Default
In seconds (0 – 90). Note: T7 is used exclusively
the IDLE however, it is superseded
state;
Timeout, T21, whenever Anytime Polling
Motion Filter
is:
A.
Set "2=Anytime OnDemand";
Set "1-Duty-Cycled" and Polling Duty-Cycle On-
B.
Time, T20, is running.
set Static Motion Filter Timeout, T7, greater than
Always
or equal to Static Motion Filter Counter, N3.
0=None
1=Start Motion Report
2=Stop Motion Report
Start & Stop Motion Reports
3=
0=Transmit ("Tx") All Messages
1=Tx Exception Reports & Query/Set
2=Tx Motion-related, Exceptions &
3=Tx IDLE Timeout, T1,
Responses
4=Tx Start/Stop, IDLE
5=Tx every 6th motion-triggered message, Exceptions &
Respones
6=Tx every 11th motion-triggered message, Exceptions &
Respones
7=Tx Start/Stop, Exception & Responses (No IDLE Status).
0
Default
0= None; 1= LED. Default
0= SMS; 1= GPRS; 2=AutoSelect. Default
TrimTrac ProE Locator Technical Manual v2.0e 118
168 20 0 0 1 0
, , , , , ,
>,<
TRANSMIT Timeout,
>,<
Almanac Timeout, T6
>,<
Report Delay Flag
43200
300
Less than 300 not recommended
900
60
168
OR
0
. Default
Responses only
Responses
Status Msgs, Exceptions
Status, Exceptions & Responses
1
0
>,<
Static
>,<
Diagnostics
.
while in
by the Dynamic
20
Default
&