TrimTrac ProE Locator Technical Manual page 117

b. "2=Sent", then ignore all data messages received prior to the
receipt of SET_ALERT_STATE message and:
i. If
Position Age
IDLE state; or
ii. If
Position Age
upon expiration of HPA Query Timeout, T17.
2. If Status is set:
MPA
a. "1=Activated", then go to immediately to the IDLE state;
b. "2=Sent" then ignore all data messages received prior to the receipt
of SET_ALERT_STATE message and go immediately to the
IDLE state.
3. If LPA Status is set:
a. "1=Activated", then go to immediately to the IDLE state;
b. "2=Sent" then ignore all data messages received prior to the receipt
of SET_ALERT_STATE message and go immediately to the
IDLE state.
4. During the QUERY state, any alert (High, Low, Medium) status can be
changed from "2=Sent" or "3=Acknowledged" to "0=Clear",
"3=Acknowledged", or "X=Do not care" upon receipt of the appropriately
configured SET_ALERT_STATE message.
is set "1=Aged", then go immediately to the
is set "0=Current", then go to the IDLE state
TrimTrac ProE Locator Technical Manual v2.0e 99