Table 31, At+Ctke Factory Default & Log Erase Command; Table 32, At+Ctkf Assignment - TrimTrac ProE Locator Technical Manual

AT+CTKE Factory Default & Log Erase Command
The AT+CTKE command restores configuration parameters back to factory
default values and erase the message log from the TrimTrac ProE device. After a
slight pause, the RDY response will appear. Wait for RDY to appear before
executing additional commands.
AT+CTKE=<Erase/Restore Mode>
OK
RDY
Erase/Restore Mode
<
Table 31, AT+CTKE Factory Default & Log Erase Command
AT+CTKF GPRS Connection Provisioning
The AT+CTKF command configures the GPRS connection provisioning
parameters. The GPRS Destination Address text field must be enclosed with
quotations
AT+CTKF=<GPRS Transport Protocol>,<GPRS Session Protocol>,<TrimTrac
Session Keep-alive Timeout, T25>,<GPRS Session Timeout, T26>,<GPRS
Destination Address>
OK
GPRS Transport Protocol
<
GPRS Session Protocol
<
TrimTrac Session Keep-
<
alive Timeout, T25
<GPRS Session Timeout,
T26>
GPRS Destination
<
Address
>

Table 32, AT+CTKF Assignment

Default AT+CTKF=1
1= Restore Defaults; 2=Erase Message Log;
>
3=Erase Log & Restore Defaults
0=UDP (TrimTrac Session Protocol mandatory);
>
1=TCP
. Default:
0=None; 1=TrimTrac Session Protocol (See
>
Separate ICD Document, v1.0)
In Seconds (0=Never; 1 –43200)
>
GPRS Session Timeout, T26
GPRS destination address in the following format:
111.222.333.444:12345. This represents an IP Address
and Port Number pair, maximum number string up to 21
characters. Must use quotation marks "_". Default:
0.0.0.0:0
0 300 0 0.0.0.0:0
, , , ," "
TrimTrac ProE Locator Technical Manual v2.0e 119
1
. Default:
. Default:
. Default:
0
300
0