Table 44, At+Ctkx? Query - TrimTrac ProE Locator Technical Manual

<Position Report Transmit
N1
Attempts, >
<Status Message Transmit
N2
Attempts, >
<Static Motion Filter
Counter, N3
>
<Dynamic Motion Filter
Timeout, T21
>
<Dynamic Motion Filter
Counter, N4
>
<Motion Sensor
Override
>

Table 44, AT+CTKX? Query

0=Until T3 Expires; 1-255=Number of Tx Attempts.
1
Default
0=Until T3 Expires; 1-255=Number of Tx Attempts.
1 if Communication Mode set "1=GPRS-only"
1
Note: This parameter is used only
In Seconds (1-90).
while Static Motion Filter Timeout, T7, is running in
superseded by the Dynamic Motion
the IDLE State. It is
Filter
Counter, N4 whenever:
A. Anytime Polling is set "2=Anytime OnDemand";
B. Polling Duty-Cycle On-Time, T20, is running due to
Anytime Polling being set "1=Duty-Cycled".
Always set Static
Motion Filter Counter, N3,
less than Static Motion Filter Timeout, T7. Default
Note: T21 applies in TRANSMIT,
In Seconds (1-90).
QUERY and DELAY States. Also applies in IDLE if:
A. Anytime Polling is set "2=Anytime OnDemand";
OR
B. Polling
Duty-Cycle On-Time, T20, is running due to
Anytime Polling being set "1=Duty-Cycled".
WARNING: Dynamic Motion Filter Timeout, T21,
must always be set equal to or greater than Dynamic
Motion Filter Counter, N4; else the unit may not exit
state.
QUERY Default
Note: This parameter is enabled only
In Seconds (1-90).
when Dynamic Motion Filter Timeout, T21, is active.
WARNING:
Dynamic Motion Filter Counter, N4, must
always be set equal to or less than the setting for Dynamic
Motion Filter Timeout, T21; else the unit may not exit
state.
QUERY . Default
0=Normal; 1=Motion Always; 2=Motion Never.
Overrides the motion sensor if set to a value other than
"0=Normal"..
0
Default
TrimTrac ProE Locator Technical Manual v2.0e 130
equal
20
10
.
Set to
. Default
OR
to or
10
Note: