Table of Contents
Advertisement
Assembly/Function
7.4
Access Points for Changing Jaw Interface
20
02.00|KSPplus-BWM KSP-LHplus-BWM |en
• Insert the clamping sleeves from the accessory pack into the
centering holes on the base plate.
• Remove the seal plugs from the base plate (internal air feed-
through III, IV) and insert the O-rings from the accessory pack
into the counterbores for the air feed-through.
• Mount the clamping block onto the base plate.
NOTE:
When joining, make sure the air feed-throughs for the clamping
system and the base plate are precisely aligned.
• Screw both parts together with the four screws (19) from the
accessory pack. Be sure to observe the tightening torques
Page
16).
• Remove the locking screws from the pneumatic connections on
the base plate.
• Connect the diaphragm pressure switch and set the switch to
the desired minimum pressure.
Functional description of quick-change jaw system
( 6,
Advertisement
Table of Contents
