Table of Contents
Advertisement
Assembly/Function
7.2
Connecting the clamping block
18
02.00|KSPplus-BWM KSP-LHplus-BWM |en
Connecting the clamping block
Make sure, that the power supply is off when connecting the
clamping block. See Chapter "Basic Safety Notes"
NOTICE
Risk of workpiece loss and damage to system from loss of air
pressure caused by damaged pneumatic lines!
Always make sure the connections are tight, and use appropriate
protective covers to protect the pneumatic hoses or lines from
hot chips.
The clamping block has four air connections: I, II, III, IV.
Two connections for OPEN (I and III) and two connections for
CLOSED (II and IV).
Which of the two hydraulic connections has to be opened for
actuation depends on the application:
• Connections I and II for operation without a base plate
( 2, Page
7).
Advertisement
Table of Contents
