Faceplate Installation - Osburn Cordova Series Installation And Operating Instructions Manual

3.3.7

Faceplate Installation

Remove the faceplate panels and the edge trim from the packaging and assemble according to the following
instructions:
1. Place the faceplate panels with the finished side down on a flat, soft, non-abrasive surface.
2. Line up the holes of the top and side panels and secure them with six (6) bolts, twelve (12) washers
and six (6) nuts (See Figure 14).
3. Assemble the faceplate trim, joining the mitred corners with
corner brackets (See Figure 15).
f i r e - p a r t s . c o m
4. Slide the trim over the edges of the faceplate assembly.
5. Secure the trim to the faceplate with four (4) brass bolts, washers and nuts (See Figure 16).
6. Insert the rocker switch into the rectangular slot of the trim and connect with the two (2) wires from
the fan assembly. This switch will control the fan operation. (See Figure 17a).
7. Place the faceplate assembly around the front of the insert. N
ON THE RIGHT HAND SIDE
Align the attachment holes and secure the faceplate to the sides of the unit with the four (4) black
8.
oxide Phillips head sheet metal screws. N
C B .
ORDOVA AY
9. Adjust the faceplate mounts to the desired setting (See Figure 17b).
Figure 14
.
OTE
: T
OTE HE ROCKER SWITCH SHOULD BE
:
D
O NOT ADJUST THE FACEPLATE DEPTH ON THE
Figure 15
/20