Vent, Gas Line, & Wiring Connections - Osburn Cordova Series Installation And Operating Instructions Manual

3.3.5 Vent, Gas Line, & Wiring Connections
Unless it is more easily installed with the insert, install the drafthood separately first as follows:
1. Disconnect the drafthood from the insert and fit its collar to the end of the previously installed vent,
whether the flue-liner in an existing masonry fireplace or the flue-liner in an existing factory built
certified fireplace.
2. Wiring:
i) Cut the plastic pull-tie securing the blue wires.
ii) Cut the plastic pull-tie securing the fan power cord to the heater.
3. Two captive nuts are attached to the air jacket bottom.
i) Remove the two 1/4"-20 screws (2.5" (64mm) long) provided with the faceplate package.
ii) Turn the screws through the two captive nuts to level the unit as required.
f i r e - p a r t s . c o m
4. Push the drafthood upward to 18 1/2" (470mm) above the hearth or fireplace bottom, and start
sliding the insert into the fireplace cavity.
5. Connect the wiring for the thermostat, wall or faceplate switch, or the remote control as noted in #2
of section 3.3.4.
6. The fan power cord is on the left side of the insert and can be routed to the right if desired. Route
the power cord along the bottom outside edge of the heater, not underneath, nor under any sharp
edges.
7. Push the insert back until the front firebox flanges are 1/4" (6mm) in front of the masonry or factory
built fireplace facing. As the heater is pushed back, pull the drafthood positioning strips firmly
toward the heater front until the drafthood flange is secured under the top clips of the heater (Figure
12).
Figure 12
/18