Faceplate Installation - Osburn 2400 Owner's Manual

Otherwise the unit can be moved back as much as 3.5" (90 mm) or any position in between. The
position chosen will depend on your own preference from most installations (where lintel is less than 6"
(152 mm) and the depth is greater than 12.5" (320 mm)). See Figure 2.2 and the table below.
MAXIMUM
EXTENDED
INCHES 8 5/16
MILLIMETRES 211
MINIMUM
EXTENDED
INCHES 11 7/8
MILLIMETRES 302
If lag-bolts and anchors are to used to secure the insert, the hole locations should be marked with
the unit in place. Remove the unit and locate the anchors.
2.6

Faceplate installation

1. Remove the faceplate panels from their box and assemble according to these faceplate
instructions.
2. Remove the slide from within the air jacket.
3. Place the faceplate face down on a flat, nonabrasive surface (see Figure 3) so that the sides are
a bit towards the middle.
4. Place the slide onto the faceplate so that the bends of the faceplate pieces go inside of the
slide.
2400 INSERT FACEPLATE BOLT ASSEMBLY:
Contents: 8 - 1/4" x 1" (6.25 mm x 25 mm) carriage bolts
I J L
6 1/2 22 1/2
165 571
I J L
10 23
254 584
M N
15 7/8 8 7/8
403 225
M N
19 1/2 5 1/4 3 7/16
495 133
Figure 3
O P AIR JACKET
7 25 Flush with
facing
178 635
O P AIR JACKET
21 7/16 Back from
facing 3 3/8"
87 545
/9