Installation; Installation & Safety Notes; Unpacking - Osburn Cordova Series Installation And Operating Instructions Manual

3 .0 Installation

3.1 Installation & Safety Notes
Read all instructions before starting installation and follow them carefully during installation to ensure
maximum benefit and safety. Failure to follow these instructions will void your warranty and may present a
fire hazard. See the Osburn warranty at the back of this manual for disclaimers regarding improper
installation. This fireplace insert and its components are tested and safe when installed in accordance with
this installation manual. This insert must never be installed in direct contact with combustible
construction.
ELECTRICAL GROUNDING NOTE: This heater fan is equipped with a three-prong (grounding) plug for
your protection against shock hazard and should be plugged directly into a properly grounded three-prong
receptacle. Do not cut or remove the grounding prong from this plug.
WARNING: Do not connect 120 VAC (240 VAC in Australia) to the gas control valve or its
wiring, as this will damage the valve.
f i r e - p a r t s . c o m

3.2 Unpacking

Please check the appliance carefully for any damaged or missing components (specifically check the glass
condition). Report any problems to your dealer. The insert is shipped with the logs and coals in separate
packages inside the firebox. The faceplate, with the levelling screws, and the grille kit are packaged
separately. All other standard parts are already in place.
3.3 Installation
For satisfactory results it is necessary to plan certain aspects of the installation prior to the appliance's final
positioning. These include the vent system, the gas piping, and the fan wiring. Combustible surfaces such as
the hearth, mantle and facing must also be planned for.
All Installations Require Venting.
N :
OTE
(In Australia, a minimum vent length of 11' (3.4m) must be used off the top of the vent collar of
the appliance).
/11