Appendix 4: Faceplate And Trims Installation - Osburn 3500-I Installation And Operation Manual

APPENDIx 4: FACEPLATE AND TRIMS INSTALLATION

Illustrations may vary by model, but the assembly method remains the same.
Hardware included with the faceplate :
• Bolts #10-24 x 1/2" (8x)
• Kit of molding brackets and screws (2x) • Nuts #10-24 (8X)
1. Remove the faceplate extension (K) secured between the firebox and the convection air jacket.
2. Place the faceplate panels with the finished side down on a flat, soft, non-abrasive surface.
Line up the holes of the upper faceplate panel (A) with the holes of the side panels (B) and (C).
Secure them together using four bolts (D) and nuts (E) provided.
Installation and Operation Manual - Osburn 3500-I
• Decorative molding fasteners (2x)
A
D
A
E
DETAIL A
A
C
B
Page 43