Table of Contents
Advertisement
Osburn Matrix Inbuilt Installation and Operation Manual
APPENDIX 3: FACEPLATE INSTALLATION
NOTE:
If the depth and or the opening of the masonry hearth require the use of the projection
kit
AC01323 and or a faceplate backing plate kit AC01322 or
AC01332,
follow the instructions
included with these options before beginning the installation of the cast iron
faceplate.
Remove the faceplate parts of the packaging
and inspect its
content. Then remove
the wing nut
that secures
the fan switch
assembly to the floor of the convection air jacket
for
transport.
The
faceplate installation requires a ratchet and 3/8''
box to secure each part to the front of the wood
inbuilt.
The back of each faceplate part is identified as follow: (A) = 24249, (B) = 24250, (F) = 24248 and (G)
= 24247.
1. Secure the fan switch assembly (D) to the faceplate (A) with 2 screws (E).
2. Align the holes in the support bracket of faceplate (A) with the screws (C) already installed on
the wood inbuilt, and then tighten the screws. Use the same procedure for faceplate (B).
44 ______________________________________________________________________________
Advertisement
Table of Contents
