Apexpro And Carescape Transmitters; Electromagnetic Compatibility (Emc; Guidance And Manufacturer's Declaration - Electromagnetic Emissions - GE ApexPro TT Technical Manual

Electromagnetic compatibility

ApexPro and CARESCAPE transmitters

Electromagnetic compatibility (EMC)

Guidance and manufacturer's declaration – electromagnetic
emissions
Emissions test
RF Emissions (radiated)
EN 55011
RF Emissions (conducted)
EN 55011
Harmonic Emissions
EN 61000-3-2
Voltage Fluctuations/
Flicker Emissions
EN 61000-3-3
B-2
Changes or modifications to this system not expressly approved by GE could cause
EMC issues with this or other equipment. This system is designed and tested to
comply with applicable regulation regarding EMC and needs to be installed and put
into service according to the EMC information stated in this appendix.
CAUTION
Use of portable phones or other radio frequency (RF) emitting
equipment near the system may cause unexpected or adverse
operation.
CAUTION
The equipment or system should not be used adjacent to, or stacked
with, other equipment. If adjacent or stacked use is necessary, the
equipment or system should be tested to verify normal operation in
the configuration in which it is being used.
The ApexPro Telemetry Transmitter is intended for use in the electromagnetic
environment specified below. It is the responsibility of the customer or user to assure
that the ApexPro Telemetry Transmitter is used in such an environment.
Compliance
Group 1 The device intentionally transmits energy in the 420-460, 584-614, or 608-
614MHz range. Nearby electronic equipment may be affected. Outside the range
Class A
of intentional transmission, the device emissions are very low and are not likely
to cause any interference.
Group 1
The equipment is suitable for use in all establishments other than domestic and
Class A
those directly connected to the public low-voltage power supply network that
supplies buildings used for domestic purposes.
Not applicable
NO AC input.
Not applicable
ApexPro™
Electromagnetic environment – guidance
2001989-351A