GE ApexPro TT Technical Manual page 56

Installation and configuration
3-16
2. At the PC, use a communication program such as HyperTerminal to set up the
ComPort connection.
Port:
Speed:
Parity:
Stop Bit:
Data Bits:
Flow Control:
3. Press Enter to get the @> Enter Service Password: prompt.
4. Type password, mms_aps (case-sensitive).
5. Press Enter.
6. At the @> prompt type ssf.
The command is "ssf x" where x identifies which antenna field(s) to enable.
Enter the "ssf x" command as listed below to configure the desired antenna
field(s).
X Field D
1 Disabled
2 Disabled
3 Disabled
4 Disabled
5 Disabled
6 Disabled
7 Disabled
8 Enabled
9 Enabled
10 Enabled
11 Enabled
12 Enabled
13 Enabled
14 Enabled
15 Enabled
7. Exit the communication program, then disconnect serial cable and PC, or
continue with step 6 in
ApexPro™
Com1 (comm port on the PC)
Baud 19200
No
1
8
Xon Xoff
Field C
Disabled
Disabled
Disabled
Enabled
Enabled
Enabled
Enabled
Disabled
Disabled
Disabled
Disabled
Enabled
Enabled
Enabled
Enabled
Setup the receiver on page
Field B Field A
Disabled Enabled
Enabled Disabled
Enabled Enabled
Disabled Disabled
Disabled Enabled
Enabled Disabled
Enabled Enabled
Disabled Disabled
Disabled Enabled
Enabled Disabled
Enabled Enabled
Disabled Disabled
Disabled Enabled
Enabled Disabled
Enabled Enabled
3-17.
2001989-351A