GE ApexPro TT Technical Manual page 30

Equipment Overview
Controls and indicators
A
B
C
D
A RA LED Used in troubleshooting
number
B Good Lead These light when testing the verify leads function.
LEDs
C Verify Leads Checks the lead/skin preparation quality. Pressing the Verify Leads button enables the good lead LEDs. After
button pressing this button, the LEDs for good leads illuminate for 1 minute.
D Battery Holds 2 AA alkaline batteries. The sliding cover of the compartment also functions as the on/off switch.
compartment
E Interface The interface connector ports (on the end of the transmitter) are used to connect the transmitter to the APEX
connector Programming Device. The TTX number and desired reference lead are programmed using the APEX Programming
ports Device. These interface connector ports may also be used to connect additional parameter devices to the
transmitter.
2-10
ApexPro
Graph
(not available)
G
H
I
J
(Frequent lead fail on page
(Manually view/program TTX on page
ApexPro CH & T14
When pressed, a 20-second graph strip is
printed on the writer or printer.
When pressed, a blue border displays
around the event bed and an alarm tone
sounds at the CIC Pro center. The message
Remote Event displays under the ECG
parameter window for approximately ten
seconds.It also generates a 20-second graph
and saves the event.
F
A
B
C
D
5-21) and when manually viewing or programming the TTX
3-19.)
ApexPro™
Function
E
317A, 420B, 432A
2001989-351A
H
I
J
K