Guidance And Manufacturer's Declaration - GE ApexPro TT Technical Manual

ApexPro receiver
Electromagnetic compatibility (EMC)

Guidance and manufacturer's declaration

Electromagnetic emissions
Emissions test
RF Emissions
EN 55011 [Radiated]
RF Emissions
EN 55011 [Conducted]
Harmonic Emissions
IEC 61000-3-2
Voltage Fluctuations/
Flicker Emissions
IEC 61000-3-3
2001989-351A
Changes or modifications to this system not expressly approved by GE could cause
EMC issues with this or other equipment. This system is designed and tested to
comply with applicable regulation regarding EMC and needs to be installed and put
into service according to the EMC information stated in this appendix.
CAUTION
Use of portable phones or other radio frequency (RF) emitting
equipment near the system may cause unexpected or adverse
operation.
CAUTION
The equipment or system should not be used adjacent to, or stacked
with, other equipment. If adjacent or stacked use is necessary, the
equipment or system should be tested to verify normal operation in
the configuration in which it is being used.
The ApexPro receiver is intended for use in the electromagnetic environment
specified below. It is the responsibility of the customer or user to assure that the
ApexPro receiver is used in such an environment.
Compliance
Group 1 The equipment uses RF energy only for its internal function. Therefore, its RF
emissions are very low and are not likely to cause any interference in nearby
electronic equipment.
Class A
Class A
The equipment is suitable for use in all establishments other than domestic and
those directly connected to the public low-voltage power supply network that
Complies
supplies buildings used for domestic purposes.
ApexPro™
Electromagnetic environment – guidance
Electromagnetic compatibility
B-7