Example 2 On Navigation: Setting The Date And Time - wtw Oxi 3310 IDS Operating Manual

Operation
Setting the date,
time and date format
22

4.4.5 Example 2 on navigation: Setting the date and time

The meter has a clock with a date function. The date and time are indicated in
the status line of the measured value display.
When storing measured values and calibrating, the current date and time are
automatically stored as well.
The correct setting of the date and time and date format is important for the fol-
lowing functions and displays:
 Current date and time
 Calibration date
 Check date (for IDS D.O. sensors)
 Identification of stored measured values.
Therefore, check the time at regular intervals.
The date and time are reset to default after a fall of the supply volt-
age (empty batteries).
The date format can be switched from the display of day, month, year
(dd.mm.yy) to the display of month, day, year (mm/dd/yy or mm.dd.yy).
1. In the measured value display:
Using <ENTER_>, open the Storage & config menu.
The instrument is in the setting mode.
2. Select and confirm the System / Clock function menu with <><> and
<ENTER>.
The setting menu for the date and time opens up.
Clock function
Date format:
Date:
Time:
01.02.2014
Back
08:00
3. Select and confirm the Time menu with <><> and <ENTER>.
The hours are highlighted.
4. Change and confirm the setting with <><> and <ENTER>.
The minutes are highlighted.
5. Change and confirm the setting with <><> and <ENTER>.
The seconds are highlighted.
dd.mm.yy
01.02.14
14:53:40
Oxi 3310 IDS (Oxi 3315)
ba75944e02 10/2014