Example 2 On Navigation: Setting The Date And Time - wtw Oxi 3315 Operating Manual

Operation
Setting the date,
time and date format
22

4.4.5 Example 2 on navigation: Setting the date and time

The measuring instrument has a clock with a date function. The date and time
are indicated in the status line of the measured value display.
When storing measured values and calibrating, the current date and time are
automatically stored as well.
The correct setting of the date and time and date format is important for the fol-
lowing functions and displays:
 Current date and time
 Calibration date
 Check date (for IDS D.O. sensors)
 Identification of stored measured values.
Therefore, check the time at regular intervals.
After a fall of the supply voltage (empty batteries), the date and time
are reset to 01.05.2011 00, 00:00 hours.
The date format can be switched from the display of day, month, year
(dd.mm.yy) to the display of month, day, year (mm/dd/yy or mm.dd.yy).
1. In the measured value display:
Open the Storage & config menu with <ENTER_>.
The instrument is in the setting mode.
2. Select and confirm the System / Clock function menu with <><> and
<ENTER>.
The setting menu for the date and time opens up.
Clock function
Date format:
Date:
Time:
01.09.2011
Back
08:00
3. Select and confirm the Time menu with <><> and <ENTER>.
The hours are highlighted.
4. Change and confirm the setting with <><> and <ENTER>.
The minutes are highlighted.
5. Change and confirm the setting with <><> and <ENTER>.
The seconds are highlighted.
dd.mm.yy
01.09.2011
14:53:40
Oxi 3315
ba75944e02 03/2012