Fn (Find Neighbors); Mac Diagnostics - Digi XBee3 DigiMesh 2.4 User Manual

AT commands
the random offset only mitigates transmission collisions, getting responses from all
devices in the network is not guaranteed.
Parameter range
20-byte printable ASCII string
Default
N/A

FN (Find Neighbors)

Discovers and reports all devices found within immediate (1 hop) RF range. FN reports the following
information for each device it discovers:
MY<CR> (always 0xFFFE)
SH<CR>
SL<CR>
NI<CR> (Variable length)
PARENT_NETWORK ADDRESS<CR> (2 Bytes) (always 0xFFFE)
DEVICE_TYPE<CR> (1 Byte: 0 = Coordinator, 1 = Router, 2 = End Device)
STATUS<CR> (1 Byte: Reserved)
PROFILE_ID<CR> (2 Bytes)
MANUFACTURER_ID<CR> (2 Bytes)
DIGI DEVICE TYPE<CR> (4 Bytes. Optionally included based on NO settings.)
RSSI OF LAST HOP<CR> (1 Byte. Optionally included based on NO settings.)
<CR>
If you send the FN command in Command mode, after (NT*100) ms + overhead time, the command
ends by returning a carriage return, represented by <CR>.
If you send the FN command through a local AT Command (0x08) or remote AT command (0x17) API
frame, each response returns as a separate AT Command Response (0x88) or Remote Command
Response (0x97) frame, respectively. The data consists of the bytes in the previous list without the
carriage return delimiters. The NI string ends in a 0x00 null character.
FN accepts a NI (Node Identifier) as an argument.
See Find specific neighbor
Parameter range
0 to 20 ASCII characters
Default
N/A

MAC diagnostics

The following AT commands are MAC/PHY commands.
Digi XBee3® DigiMesh RF Module User Guide
for more details.

MAC diagnostics

47