Figure 78 - Nonstandardt - Geokon GK-405 Instruction Manual

50
Temperature Display: Selects which units to display the temperature in. The choices are
Celsius or Fahrenheit. This feature is not affected by sensor type and is always enabled to
allow temperature units to be selected.
4.2.4.2 Temperature Display Feature:
Display Units: Selects which units to display the temperature in. The choices are
"Celsius" or "Fahrenheit". This feature is not affected by sensor type and is always
enabled to allow temperature units to be selected.
Thermistor Type: Allows selection of the Thermistor type. Valid selections are
"Standard", "High-Temp 8.2K", "High-Temp 10K" or "Other". The first three are
Geokon thermistor offerings based on the type of sensor purchased. Selecting the "Other"
choice causes four more text boxes to be displayed (Figure 78) where up to four
thermistor coefficients may be entered if a nonstandard thermistor is used. (Note: If a
thermistor only uses three coefficients, enter the A, B and C coefficient and set the D
coefficient to zero.)
Figure 78 - Nonstandard Thermistor Coefficients