Data Storage; Automatic Stability Control - wtw Oxi 3315 Operating Manual

Oxi 3315
Menu item
System /
Interface /
Baud rate
System /
Interface /
Output format
System / Interface / Deci-
mal separator
System / Interface / Out-
put header
System /Clock function
System /Service informa-
tion
System /Reset
ba75944e02 03/2012
Possible setting
1200, 2400,
4800, 9600,
19200
ASCII
CSV
Dot (xx.x)
Comma (xx,x)
Date format
Datum
Time
-

6.2.2 Data storage

This menu contains all functions to display, edit and erase stored measured
values.
Detailed information on the memory functions of the Oxi 3315 are
given in section 7 D

6.2.3 Automatic Stability control

The automatic Stability control (AutoRead) function continuously checks the
stability of the measurement signal. The stability has a considerable impact on
the reproducibility of measured values.
You can activate or switch off the automatic Stability control function (see
section 6.2 S -
ENSOR INDEPENDENT SETTINGS
The measured parameter flashes on the display
 as soon as the measured value is outside the stability range
 when the automatic Stability control is switched off.
Description
Baud rate of the USB Device interface
Output format for data transmission
For details, see section 8 T
), page 44
INTERFACES
Decimal separator
Output of a header for Output format: CSV
Settings of time and date.
For details, see section 4.4.5 E
: S
TION ETTING THE DATE AND TIME
Hardware version and software version of the meter
are displayed.
Resets the system settings to the default values.
For details, see section 6.3.2 R
, page 37
TEM SETTINGS
, page 38.
ATA STORAGE
, page 34).
Settings
(USB
RANSMITTING DATA
2
XAMPLE ON NAVIGA
, page 22
ESETTING THE SYS
-
-
35