Step 6: Connecting To The Network - Xantrex Freedom SW 230V Installation Manual

Step 6: Connecting to the Network

For your reference, Figure 14 shows where the network
connections are made on the Freedom SW 230V.
To connect the Freedom SW 230V to the Xanbus network:
◆ Plug a network cable connected to the Xanbus network
into either one of the two Xanbus Interface network ports
on the Freedom SW 230V.
EQUIPMENT DAMAGE
Connect the Freedom SW 230V only to other Xanbus compatible devices.
Although the cabling and connectors used in this network system are the
same as Ethernet connectors, this network is not an Ethernet system.
Equipment damage may result from attempting to connect two different
systems. Do not attach the Freedom SW 230V On/Off switch to these
ports.
Failure to follow these instructions can damage the unit and/or damage
other equipment.
Detailed information on planning and installing your network
is available in the Xanbus System Installation Guide. Refer to
the this guide to determine the type of network layout to
install, as well as guidelines for installing the network.
975-0697-01-01
The Xanbus System Installation Guide is available for
download at
www. xantrex.com
In v
E n
t
s e
R e
in g
c k
S t a
c e
e r fa
In t
u s
n b
X a
Figure 14 Connecting to a Xanbus Network Port
Installing the Inverter/Charger
u lt
/ F a
A C
e
e r a r g
e r t C h
In v le d
a b
E n
e r
e r t
le
a b
Connect only
Xanbus-enabled
devices. Ports
are not intended
for the On/Off
Switch.
39