Table of Contents
Advertisement
Installation Tools and Materials
Tools
You will need the following tools to install the Freedom SW
230V and the battery temperature sensor.
❐ Wire stripper
❐ Crimping tools for fastening lugs and terminals on DC
cables
❐ Phillips screwdriver: #2
❐ Slot screwdriver (6 mm wide blade max)
❐ Needle-nose pliers
❐ Wrench for DC terminals: 15 mm
975-0697-01-01
Materials
You will need the following materials to complete your
installation:
❐ Strain-relief clamp(s) for AC cables (not provided): trade
sizes are 3/4" (Ø28.3mm) and/or 1" (Ø34.6mm)
❐ DC battery cables
❐ Lugs for DC cables (for 10 mm stud size)
❐ Copper wire for DC grounding: 8 mm
Grounding" on page 15
❐ Lugs for DC grounding cable (for M6 stud size)
❐ AC and DC disconnect switches and overcurrent protective
devices and connectors as required. See page 14.
❐ AC output and input wire. See Figure 3 on page 8.
❐ If the AC ground wire is stranded, each ground wire requires
a ring terminal
❐ Six M6 steel screws or bolts to mount the unit
❐ Inverter drip shield (PN: 808-9004) if mounting in marine
installation
NOTE: For a list of tools and materials required to install the
network, refer to the Xanbus System Installation Guide,
which is available for download at www.xantrex.com.
Planning Preparations
2
. See "DC
17
Advertisement
Table of Contents
