Connecting Ac Input Wires - Xantrex Freedom SW 230V Installation Manual

Installing the Inverter/Charger

Connecting AC Input Wires

Figure 6 shows the wiring compartment, which contains a
grounding bus (used to wire the AC input and output ground
wires) and a terminal block (used to wire the AC input and
AC output connections).
NCORRECT BATTER
WIRING BOX COVER MUST BE IN PLACE DURING
OPERATION TO REDUCE RISK OF INJURY TO PERSONS.
Figure 6 AC Wiring Compartment
26
AC
OUT
AC GROUNDS
(BEHIND COVER)
To ground bus
EQUIPMENT DAMAGE
The terminal block is split into INPUT and OUTPUT sections. Damage may
occur if the unit is wired incorrectly.
Do not remove or loosen factory installed wiring.
Failure to follow these instructions can damage the unit and/or damage
other equipment.
When making the AC input and AC output connections,
observe the correct color code for the appropriate AC wire, as
described in Table 1 on page 13.
To make the AC input connections:
1. Locate the wiring compartment cover panel and remove
the four screws.
2. Remove the cover panel from the unit to access the wiring
compartment.
3. Remove one of the AC knockouts from the front or side
of the unit. Do not leave the knockout inside the wiring
compartment.
4. Install a strain-relief clamp in the AC knockout.
5. Run the AC wiring through the strain-relief clamp.
Freedom SW 230V Installation Guide