Extreme Networks BlackDiamond 10K Series Installation Manual page 73

8 Ensure that the module is vertical with the module name at the top, the PCB to the right, and that
the ejector/injector levers are extended.
a Slide the module into the appropriate slot of the chassis until it makes contact with the
backplane.
NOTE
Use the metal panel, not the PCB, to guide the I/O module
As the module begins to seat in the chassis, the ejector/injector levers begin to close.
b To close the ejector/injector levers, use both hands simultaneously to push the levers toward the
center of the module.
c To secure the module, tighten the two captive screws using a #1 Phillips screwdriver.
NOTE
Tighten the screws of this module before inserting additional modules. Otherwise, you might unseat
modules that you have not secured.
Extreme Networks BlackDiamond 10K-Series Switch Installation Guide
Open ejector lever
Lock
Lock
Captive
Open
screws
Injector/
Open
Injector/
ejector lever
Installing I/O Modules
Lock
Lock
Open
EX_017
73