Antennas; Gsm/Umts; Gnss; Device Identification Label - Logic IO RTCU MX2 turbo Technical Manual

RTCU MX2 turbo Technical Manual V2.04

Antennas

GSM/UMTS

The RTCU MX2 turbo contains an SMA female connector for connecting a suitable GSM/UMTS
band antenna. When installing the antenna, please make sure that the antenna is not in close
proximity to metallic parts or anything else that can influence the efficiency of the GSM antenna.
Please consult the installation guide that follows the GSM antenna.

GNSS

The RTCU MX2 turbo supports GPS, GLONASS and QZSS so a suitable GNSS antenna must
therefore be used. The connection is with an SMB Male connector and the GNSS antenna must be a
3V active antenna with a SMB Female connector.
When installing the antenna, please make sure that the antenna has a reasonable view of the sky,
so that it can receive the weak signals from the satellites. Please also consult the installation guide
that follows the antenna.

Device identification label

The barcode found on the MX2 turbo unit contains the serial number. The first three digits in the
serial-number identify the unit type.
For the RTCU MX2 turbo this unique code is 292 or 286. For the RTCU MX2 turbo-2G the code is
293 or 285.
The barcode format used: 2/5 Interleaved with Check Digit.
Logic IO ApS. Ph: (+45) 7625 0210
Holmboes Allé 14 Fax: (+45) 7625 0211
8700 Horsens Page 27 of 36 Email: support@logicio.com
Denmark www.logicio.com