Rtcu Mx2 Turbo Specifications - Logic IO RTCU MX2 turbo Technical Manual

Table of Contents

Advertisement

RTCU MX2 turbo Technical Manual V2.04
RTCU MX2 turbo
Processor and Main-memory
Powerful 32-bit ST ARM7 processor.
2112 KB fast execution RAM.
4532 KB Flash for firmware/application.
Storage
7.5 MB persistent data flash.
8 MB internal FAT32 flash drive.
1 MB circular automatic datalogger.
20 KB FRAM with fast access /
unlimited write endurance.
SD-CARD reader with up to 32 GB.
UMTS/GSM
3G / Quad-band with up to 3.6 Mbps.
UMTS / EDGE / GPRS support.
CSD with up to 64 Kbps (3G only)
SMS / PDU.
DTMF decoding / transmission.
Digitized voice playback / IVR.
eCall prepared.
Mini-SIM 1.8/3 volt.
External and internal SIM card-reader.
Switchable from the application.
GNSS / GPS
Mediatek MT3333 Multi-GNSS chip.
GPS, GLONASS and QZSS.
99 acquisition / 33 tracking channels.
SBAS (WAAS,EGNOS,MSAS,GAGAN).
Position update with up to 4 hz.
A-GPS capable.
Sensitivity.
Tracking: -165 dBm
Reacquisition: -160 dBm
Cold start: -148 dBm.
Accuracy: < 2.5m CEP.
Anti-jamming, Noise cancellation.
Active 3 volt GNSS antenna.
Logic IO ApS.
Holmboes Allé 14
8700 Horsens
Denmark
Specifications
Battery and Charger
On-board 2Ah (nominal) Li-Ion battery.
Intelligent charger with temperature
throttle and sub-zero degrees support.
On-board temperature sensor.
Digital/Analog Interface
4 x digital solid-state digital output.
Max. 36 volt / 1.5 A per. channel.
Short-circuit, ESD, Inductive kick-back
protected up to 20 mH.
5 x digital inputs.
Logic high: 8 to 40 VDC.
Logic low: -5 to 3 VDC.
Digital input #5 can be used as ignition.
2 x analog inputs.
Range is 0..10V.
Resolution: 12 bit
Precision: ±1.5% FSR @ 25°C
Protected against transients and low-
pass filtered.
Expandable I/O with MODBUS.
Communication
Full CAN2.0B with hardware filtering
and multi-speed support.
1 x RS232 with control signals.
1 x RS232 with RX/TX.
Alternatively used as service port.
1 x RS485 with MODBUS support.
1-Wire bus.
Power Management
5 execution speeds.
Wait for Event: Timer, Digital input,
RS232, CAN, GSM, Accelerometer and
power change state.
Wait for event, from: 300 uA@12V.
Supervision of supply voltage.
Disable external power.
Accelerometer
3-axis digital acceleormeter.
Resolution: 12 bit @ ±16g.
Low-power mode.
* * * * END OF DOCUMENT * * * *
Page 36 of 36
External Interfaces.
SIM-card slot for micro-SIM with lock and
presence detection.
SD-CARD slot with presence and write
protect detection.
Micro-jack 2.5" connector for hands-free.
Audio out for digitized voice playback.
4 x LED indicators and 2 x DIP switches.
Reset/recovery switch,
TE-Connectivity "Mate'n'Lock':
RS232, I/O, Power, Communicaton.
RJ45 for RS232 with full control signals.
SMA Female connector for GSM.
SMB Female connector for GNSS/GPS.
Physical Characteristics
Encapsulation: Aluminum/plastic.
Optional mounting bracket.
Approx. 300 gram without accessories.
W 97 x H 35 x D 132 mm.
(without antenna connectors).
Environmental Specification
Operating temperature: -35 to 60°C.
Battery charge temperature:
-10 to 45 °C
Recommended storage temperature:
0 to 45°C.
Humidity: 5..90% (non condensing).
Approvals
E1 type approval:
2004/104/EC UN ECE R10 - ed 3.
CE mark / Applied R&TTE directive.
GSM engine: CE/GCF/FCC/PTCRB.
Warranty
Two-years return to factory parts and
labor.
Optional warranty up to 5 years.
(restrictions apply).
Technical data are subject to changes.
Ph: (+45) 7625 0210
Fax: (+45) 7625 0211
Email: support@logicio.com
www.logicio.com

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the RTCU MX2 turbo and is the answer not in the manual?

Subscribe to Our Youtube Channel

Table of Contents