Installing The Burn Media - Rinnai Arriva 752 Installation Manual

Installing the burn media

Only the burn media designed for the Arriva 752 (black stones, and white quartz) can be used.
NEVER install burn media from other fires, or mix burn media as this can create a dangerous
installation. Please read these instructions carefully as incorrect placement of the stones or
quartz is not covered under warranty.
Remove combustion chamber glass
Before the burn media can be installed the
combustion chamber glass panel needs to be
removed.
1. Remove the two retaining screws that secure
the combustion chamber glass panel to the
heater engine.
2. Rotate and lift the combustion chamber glass
clear of the combustion chamber and place in
a safe location until required.
Installing the small black stones
Place stones in the gap between the retaining
wall and the stainless steel burner shelf until
it has been completely filled. Place remaining
stones evenly (AVOID any large gaps) onto the
burner shelf.
3.
Important
DO NOT place the stones onto the burner
plates.
12 | Arriva 752 Installation Guide: 12218-F 06-18
Stones
Burner shelf
Retaining
screws
Installing the large and small white quartz
1. Place the six large quartz pieces evenly
along the centre of the burner shelf.
2. Place the small quartz pieces in the gap
between the retaining wall and the burner
shelf until it has been completely filled—
AVOID any large gaps.
3. Place the remaining small quartz pieces
evenly around the six large quartz pieces
on the burner shelf.
Large quartz
3.
Burner shelf
Important
DO NOT place the quartz onto the burner
plates.
Combustion
chamber glass
Small quartz