Stainless Steel Main Top; Control Panel And Oven Doors; Oven And Divider - Falcon 900S Dual Fuel User's Manual & Installation Instructions

Stainless steel main top

Lift away pots or pans from the main top. Remove the pan
supports from the spillage area and carefully place in a sink of
warm soapy water. Wipe loose debris from the main top.
For best results use a liquid detergent cleaner. Rinse with cold
water and thoroughly dry with a clean, soft cloth. Make sure
all parts are dry before repositioning.

Control panel and oven doors

The control panel and control knobs should only be cleaned
with a soft cloth wrung out in clean hot soapy water – but
take care that no surplus water seeps into the appliance. Wipe
with a clean dampened cloth then polish with a dry cloth.
The oven doors should only be cleaned with a soft cloth
wrung out in clean hot soapy water.

Oven and divider

Clean the oven and divider with a proprietary oven cleaner,
suitable for enamel.
IMPORTANT: Before cleaning the divider make sure to
remove the silicon sealing strip from the front edge – some
oven cleaners can damage the seal. Remove the strip by
gently pulling both ends to release the hooks holding it in
place.
IMPORTANT: Do not immerse the divider in water. This may
cause damage.
Removing the oven linings
Remove the shelves first. To remove the oven shelf supports
lift until clear of the two supporting holes and pull outwards
(Fig. 5.4).
Note: There are specific liners for the left and right hand sides.
To remove the side panels, simply lift the panel and slide
forwards.
Replacing the oven linings
To replace the liner the cut-out section must be at the top of
the liner. Slide the liner towards the back of the oven cavity.
When this is in place the shelf supports can be replaced. To
do this, first insert the bottom of the support in the cut-out
followed by the two hooks at the top (Fig. 5.5).
ArtNo.281-0019 - Removing the shelf support
ArtNo.281-0020 Removing the liner
15
Fig. 5.4
Fig. 5.5