Huawei NetCol5000-A User Manual page 138

NetCol5000-A 42 kW Air Cooled In-row Precision Air
Conditioner
User Manual
Task
Indoor
fan
Water pan filter
Open the water pan cover at the front door, and you can see the water pan filter.
shows how to remove a water pan filter.
Issue 01 (2017-07-27)
Baseline Requirement
Wear protective gloves and touch
the compressor angle valve (as
shown in Figure 5-11), needle
valve, and soldering points in the
refrigerant pipe to check whether
there are oil stains.
No water exists under the water
pipe or on the thermal insulation
foam.
The refrigerant pipe support is
secure and intact.
The indoor fan guard is not
deformed, and the fan blades are
not damaged.
The indoor fan runs smoothly.
The screws on the indoor fan are
not loose or distorted.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
5 Operation and Maintenance
Troubleshooting
and then charge new refrigerant.
NOTE
If the sight glass does not obviously turn
green, use a blow drier to blow wind to the
filter until the sight glass is green.
If there is an oil stain, check whether the
suction and exhaust pressure of the
compressor is within the normal ranges.
(For the proper ranges of suction and
exhaust pressure of the compressor, see
4.7 Charging the Remaining
If the pressure is beyond the normal
range, contact Huawei technical support.

If drops of water are evenly
distributed, wipe off them with a dry
cloth.
 If there are large water marks, close
the water inlet sluice and process the
leak points. If the thermal insulation
foam is damaged or missing, lay out
new thermal insulation foam.
Replace the refrigerant pipe support and
secure it again.
Replace the fan. 5.4.2 Replacing the
Indoor Fan describes how to replace a fan.
Take out the foreign matter.
Tighten the screws using a 10# socket
wrench.
Refrigerant.)
Figure 5-1
130