Table of Contents
Advertisement
EXTERNAL SAFETY AIR BLEED KIT INSTRUCTIONS
6. Install the tee assembly by threading into the hole where you
removed the pressure gauge ( Fig. 24 Pg. 17 ) .
7. Insert one end of the tubing into the compression fitting ( Fig. 24 Pg. 17 ) .
8. Turn the power on to the pump and check that air is coming from the
other end of the tubing.
9. Turn the power off to the pump.
10. Pick a spot on the return pipe downstream of all other devices
(heater, chlorinator, pressure cleaner, etc.)
11. Drill a 7/16" hole through the return pipe at the location
selected.
12. Install the saddle clamp with the fitting over the hole.
Make sure the gasket is in place between the fitting and the pipe.
( Fig. 24 Pg. 17 )
13. Lay the tubing along the return pipe to the saddle clamp fitting and
cut off excess length.
14. Connect the end of the tubing to the compression fitting on the
saddle clamp ( Fig. 24 Pg. 17 ) . The tubing can be secured to the
pipe using cable ties (not included).
NOTE:
Ozone production from direct UV light will decline over time. UV bulbs
continue to illuminate after they stop producing an effective level of ozone
to clean your pool water. To make sure your pool continues to receive all the
benefits of ozone, Paramount recommends that you replace your bulb every
three (3) years.
WARNING:
• Turn off power at main source before making any electrical
• UV light produced by this unit is harmful to the eyes and
For technical assistance call 1.800.621.5886 or contact your regional representative
(OPTIONAL) (CONT.)
BULB REPLACEMENT
connections or servicing the unit.
may cause blindness! Do not look directly at a lit bulb!
18
Advertisement
Table of Contents
