Table of Contents
Advertisement
CONVERTING BALLAST VOLTAGE TO ALTERNATE SETTING
the ballast and a nut
holding the two ground
wires in place. ( Fig. 35 )
10. On the back of the unit
nearest the open end,
remove the flatheaded
screw with a Phillips
screwdriver while holding
the lock nut on the inside
of the cavity with pliers. ( Fig. 36 )
11. Pull the ballast plate free from housing.
12. On the side of the ballast is a switch to select voltage. Push
the switch closest to the desired setting(120V or 240V) ( Fig. 7 Pg. 8 )
13. Reassemble in reverse.
14. Be sure to install ground wire connectors under lock nut, holding
ballast in place ( Fig. 35 Pg. 22 ) .
For technical assistance call 1.800.621.5886 or contact your regional representative
(CONT.)
Fig. 36
23
Advertisement
Table of Contents
