Table of Contents
Advertisement
TO COMPLETE INSTALLATION YOU WILL NEED THE FOL-
(1) Six (6) feet 1/2" non-metallic conduit outdoor rated.
(1) 1/2" conduit compression fitting.
SELECTING LOCATION & MOUNTING UNIT
1. Select a location on a wall near the pool equipment or insert posts into the
ground, which will be used to hang unit. The Clear O3
one (1) foot above maximum water level, and for extra safety the unit should
be mounted higher than the filter. The unit should be within five (5) feet of an
electrical source, and within nine (9) feet of plumbing connection. A solid
surface is necessary to mount unit. Mounting brackets are horizontally
adjustable to line up with hard points on the mounting surface. The unit must
be mounted horizontally and level on the wall. Electrical connections should
be facing downward.
2. Use provided screws and plastic wall inserts
or poles and pole mount clamps (not included) depending on installation
surface available.
3. Four (4) mounting
brackets are
included (two for the
top slot and two for
the bottom slot.
4. Install anchors and
screws in desired
location for the top
hangers. They must
be no further apart than twelve (12) inches. Do not tighten screws all the way.
( Fig. 1 )
5. Hang the Clear O3
over the screws.
For technical assistance call 1.800.621.5886 or contact your regional representative
LOWING ITEMS (NOT INCLUDED)
Fig. 1:
®
from the two top brackets by sliding the keyhole slots
5
®
unit should be at least
Advertisement
Table of Contents
