Table of Contents
Advertisement
Clean filter and pump
1.
basket before setting
airflow.
Turn the knob on the
2.
needle valve/flow
meter clockwise to
close valve completely.
Turn the power on to
3.
the pump
Turn the knob on the
4.
needle valve/flow
meter counter clockwise until the ball reads in the middle of the two
lines on the flow meter. ( Fig. 22 )
IMPORTANT NOTES REGARDING THE FLOW METER:
1. IF THE PUMP THAT THE CLEAR 03
RUNNING A PARAMOUNT IN-FLOOR SYSTEM, lock the water valve on pause
when the valve is switching ports and therefore at it's maximum flow (the pause
control is located on top of the Paramount water valve). Set the flow meter so the ball
is on the upper line of the Ideal range.
2. WHEN USING MULTIPLE SPEED PUMPS, SET THE FLOW METER WITH
THE PUMP RUNNING ON THE HIGHEST SPEED THAT WILL BE USED.
3. The Clear O3 flow meter is very sensitive and the red ball may drop down below
the 'ideal' marker after it has been set. If this happens on your unit, please be aware
that this is normal. The flow meter will still deliver the proper amount of ozone as long
as the blue light is on. You do not need to reset the flow meter until after you clean
your filter.
For technical assistance call 1.800.621.5886 or contact your regional representative
SETTING AIR FLOW
Fig. 22
®
UNIT IS INSTALLED ON IS A PUMP
16
Advertisement
Table of Contents
