Bulb Replacement - Paramount Fitness ClearO3 Installation Manual

Water purifying system

Hide thumbs

Table Of Contents

Table of Contents

Mounting Instructions

1. Turn the power off to the pump.

2. Remove the pressure gauge from the filter.

3. Install the nipple into one end of the brass tee.

4. Install the pressure gauge by threading into

the other end of the brass tee supplied.

5. Install the tubing compression fitting by

threading into the side of the brass tee.

6. Install the tee assembly by threading into the

hole where you removed the pressure gauge

(Fig. 21).

7. Insert one end of the tubing into the compression fitting (Fig. 21).

8. Turn the power on to the pump and check that air is coming from the other end of the tubing.

9. Turn the power off to the pump.

10. Pick a spot on the return pipe downstream of all other devices (heater, chlorinator, pressure cleaner, etc.)

11. Drill a 7/16" hole through the return pipe at the location selected.

12. Install the saddle clamp with the fitting over the hole. Make sure the gasket is in place between the fitting

and the pipe. (Fig. 21)

13. Lay the tubing along the return pipe to the saddle clamp fitting and cut off excess length.

14. Connect the end of the tubing to the compression fitting on the saddle clamp (Fig. 21). The tubing can be

secured to the pipe using cable ties (not included).

NOTE: Ozone production from direct UV light will decline over time. UV bulbs continue to illuminate after they

stop producing an effective level of ozone to clean your pool water. To make sure your pool continues to receive

all the benefits of ozone, Paramount recommends that you replace your bulb every three (3) years or 13,000

operating hours.

DANGER

Fig. 21

FROM

PUMP

Installation of External Safety Air Bleed Kit