Table of Contents
Advertisement
CONVERTING BALLAST VOLTAGE TO ALTERNATE SETTING
While holding the bulb, wiggle the plug to
5.
loosen from the bulb and pull it free from
light bulb. ( Fig. 33 )
Pull the light bulb from the unit.
6.
7.
With a Phillips screwdriver, remove the
two (2) screws inside the electrical
housing next to the light bulb hole that
connect the electrical housing to the
aluminum housing. ( Fig. 34 )
While holding the aluminum housing,
8.
remove the electrical housing by pulling
from the end of the unit.
(Wires do not need to be
disconnected.)
Inside the back cavity of the
9.
aluminum housing you will see
For technical assistance call 1.800.621.5886 or contact your regional representative
(CONT.)
Fig. 34
Fig. 35
22
Fig. 33
Ground
Wire
Advertisement
Table of Contents
