Manual Range Per Axis; Unit Display On Y Axis - Kollmorgen AKD PDMM series User Manual

AKD PDMM User Guide | 13.3.7 Manual range per axis
The zoom functionality allows you to navigate in a portion of the graphic. When you reset the zoom, the ini-
tial scales are shown.
In the display tab, when "Remember Axis Scale" is set, the scales of the axes are kept between two
sequential recordings. You can fine tune the scale to visualize a particular behavior and record a second
time and see the same behaviour without having to redo all the tuning. When not checked, a scale to fit all
will be performed after each record. This setting is reseted when exiting EWV and should be explicitly set
at next startup.

13.3.7 Manual range per axis

After recording data, right click anywhere on the y-axis and select Set Manual Scale to open a dialog box
to set the range for the axis. Enter the Y-axis minimum value and Y-axis maximum value. Click OK to
reset the Y-axis to new range.

13.3.8 Unit display on Y axis

The unit on the Y-axis is displayed if all scope signals units are identical for that Y-axis. If different units
apply to different signals, the units are displayed as [-]. For example, if the velocity Y-axis has signals
VL.FB and IL.CMD, then the unit displayed is [-], since the units for these parameters are different. If
IL.CMD is hidden, then the correct unit for VL.FB, rpm, is displayed.
Related Parameters:
BODE Parameters (pg 222)
Kollmorgen™ | December 2012 113