Save Settings; Load Settings; Changing Oem Name - CAB A2+ User Configuration Manual

6 Service Functions
4
6.4

Save Settings

Access only possible with memory medium in the default card slot!

With the Save settings function the printer configuration can be saved to a memory medium (memory card, USB
flash drive, Internal Flash File System) in the default card slot. The configuration will be saved as XML file in the
folder \MISC of the CF card. The current date is used as file name YYYYMMDD.XML (e.g. 20070427.XML for a file
saved on 04-27-2007).
1. Insert memory medium.
Press the menu button.
2.
3. Select Service > Save settings menu.
If the function Save settings is protected via a PIN, use the buttons ~, €, | and } to enter the code number
4.
and confirm with the  button.
Saving of the configuration data starts. OK is shown in the display when the entire saving procedure is complete.
5.
Press the  button.
6.
7. Do not remove the memory medium until the saving procedure is complete.
An error message appearing during the saving procedure may be caused by an unreadable medium (e.g. unknown
card type, unformatted card)  "9.3" on page 47.
6.5

Load Settings

Access only possible with memory medium in the default card slot!

A printer configuration previously saved to a memory medium (memory card, USB flash drive, Internal Flash File
System) can be loaded with the Load settings function.
1. Insert memory medium.
Press the menu button.
2.
3. Select Service > Load settings menu.
If the function Load settings is protected via a PIN, use the buttons ~, €, | and } to enter the code number
4.
and confirm with the  button.
If several configuration files are found on the memory medium, select the desired file with the ~ and € buttons.
5.
Press the  button.
6.
Loading of the configuration data starts. Do not remove the memory card until the loading procedure is complete.
OK is shown in the display when the entire loading procedure is complete.
Press the  button.
7.
If an error occurs during the loading procedure, an error message appears in the display. Restart the loading
procedure in this case. If an error occurs again, the configuration parameters must be entered via the operating
panel.
6.6

Changing OEM Name

Access only when service key is inserted!
The device designation cam be changed with the OEM Name function.
1. Insert service key into a USB master interface.
Press the menu button.
2.
3. Select Service > OEM Name menu.
Press the  button.
4.
A list of available names is shown in the display.
Use the ~ and € buttons to select the desired OEM name.
5.
Press the  button.
6.
4