Wifi Status - CAB A2+ User Configuration Manual

5 Test Functions
5.6

WiFi Status

Access only when a WLAN card is installed!

Function not available at A2+ !

The WiFi status function prints out a list the most important parameters of the accessible Wireless Access Points.
The printout occurs using the heat level and print speed specified in the Setup > Print param. menu.
Notice!
i
The printout occurs without taking the label gaps into consideration. This is why endless media are most
suitable for this purpose.

Insert printable medium (labels, endless paper) which extends across the entire printing width.

If the printout is to occur using thermal transfer printing, insert transfer ribbon with the maximum width.
Press the menu button.


Select Test > WiFi status print menu.
 Start printout with the  button.
The printout can be cancelled with the cancel button.
Mach4/300 - 10/09/2007 -15:21:00
Firmware V3.11 (Aug 9 2007) - #111070553751
Channel Name/BSS ID
6 MyNet
00:11:6B:61:8D:C1
11 BT4233SA70
00:11:6B:61:AB:82
Fig. 14 WiFi status
The parameters have the following meaning :
Column
Channel
Name/BSS ID
WiFi signal
strength
Encryption
Table 18 Parameters of the WiFi status
WiFi status
WiFi signal strength Encryption
●●●●● WPA-PSK (TKIP)
54,0 MBit/s
●○○○○
WEP
54,0 MBit/s
Meaning
Channel; frequency range of the Access Point
Name of the wireless LAN
MAC address of the Access Points
Scale of the WiFi signal strength
Data transfer rate
Type of data encryption