Polycom MGC-25 Release Notes page 44

MGC Release Notes - Version 7.0.4
Table 8: Pending Issues (Continued)
#.
10.
11.
12.
13.
14.
15.
16.
17.
18.
40
Category Description
FTP FTP service on XPEK may stop
working, affecting system functions,
such as prevent the Logger Diagnostic
Files from opening and causing MGC
Manager application to close.
Interop In a Continuous Presence H.261
conference, FX endpoints do not show
Content.
Gatekeeper Gatekeeper CON (Conference On
CON Demand) does not work with the
MGC-25. When deleting active
conferences with two or more
participants, asserts can occur.
Gateway When the MGC unit is used as a
gateway and an endpoint is used as an
MCU for multipoint connections, using
FECC or H.239 may cause the MCU
endpoint to display only one participant
(as in a standard gateway session).
Gateway When connecting conferences using
the Gateway and you move a
participant to and from a conference, no
video can been seen.
Gateway When the MGC unit is used as a
gateway and one endpoint is used as
an MCU for multipoint connection, if the
connection has started with video
protocol H.264, other participants using
a video protocol other than H.264
cannot connect to the endpoint-MCU.
Gateway When calling from H.323 endpoint to an
EQ placed on MGC V6 (used as an
MCU) through MGC V7 (used as GW
H323->H320), the call fails.
General When moving a participant from one
conference to another, the "First to join"
IVR message is heard twice.
General When the MGC Manager uses port 80
to connect to the MGC unit, the MGC
Manager may disconnect from the
MGC unit (Bad connection status)
ID# Remarks
20433 In the IP
Terminal, enter
restore_ftp. If
the system
displays an
indication that
the ftp cannot be
restored, reset
the MCU. If MCU
reset is not
applicable, call
support.
21899
20477
19297 Disable the
FECC and H.239
options for the
gateway call or
set the
system.cfg flags:
GW_EPC_H239
and FECC_GW
to NO.
19469
19635 Set the gateway
call to H.263 or
set the
system.cfg flag
GW_H264 to NO
(default).
20232
19515
20317 Use port 5001
instead