Software Upgrade Procedure; Upgrade Checklist; Mcu Disk Space Verification - Polycom MGC-25 Release Notes

MGC Release Notes - Version 7.0.4

Software Upgrade Procedure

Upgrade Checklist

Prior to upgrading to Version 7.0.4 it is recommended you perform the following steps:
1.
2.
3.
4.
5.
6.
7.
8.
9.

MCU Disk Space Verification

IP Terminal can be used to verify the disk space on the MCU. This verification is applicable
to both PSOS and XP operating system.
To verify the disk space on the MCU:
1.
2.
6
Verify the amount of free disk space on the MCU. For details, see "MCU Disk Space
Verification" below.
Backup configuration and Reservations. For details, see the MGC Administrator's
Guide, Chapter 5.
Removing a redundant configuration file. For details, see "Removal of Redundant
Configuration Files" on page 13.
The system saves the network cards' circuit ID assignment during the upgrade process.
However it is recommended that you document the network cards' circuit ID
assignments and order.
Version 7.0x requires the installation of a hardware key (dongle) on the MCU. For
details see "Dongle Upgrade Instructions" on page 8.
Install the new MCU version. For details see "MGC Unit Software Upgrade
Procedure" on page 12.
Install the new system.cfg file. For details, see MGC Administrator's Guide,
Chapter 5, Send File section.
Install the new MGC Manager version. For details, see "Installing the MGC Manager
Software" on page 15.
Back up the configuration (Backup Configuration) and database files (Backup
Reservations) to create backups that are compatible to the new version.
Right-click the MCU icon, and then click IP Terminal.
The Donkey-COM window opens.
In the command line of the Donkey-COM window, type disk_stat and press Enter.