Lynxmotion AL5D-PLTW Manual page 57

Step E2 : The arm needs to be fixed to a base or else it will fall over. We suggest a flat piece of
wood at least 12" x 12". The electronics carrier is meant to be placed on the same side as the
"back" (where the cutout is from step 10) as shown. When doing so, be sure to route the base
rotate servo wire through the cutout so the base can lay flat on the surface, and verify that it isn't
being pinched. You can use the included #4 x .500" tapping screws (i.e. wood screws) as part of
the base rotate hardware bag to secure the assembly to wood.
Step E3 : Carefully bend the wrist servo back as far as it will go, and use zip ties to secure the
servo cables as shown. Make sure to leave slack in the gripper servo cable, don't pull it too
tight.
RobotShop Inc. 305-18005 Lapointe, Mirabel, Quebec, Canada, J7J0G2
56