Lynxmotion AL5D-PLTW Manual page 22

Step A14 : Install the SSC-32 (shown) or the SSC-32U using four more 1/4" hex socket screws.
Do not make the electrical connections yet.
Step A15 : Twist each end of the multi-strand wires to ensure there are no loose wires which can
cause a short circuit. This will also make the multi-strand wires easier to insert into the screw
terminal.
Unscrew the VS1+ and VS1- terminals so the wires can be inserted. This means rotating the
screw so that the inner metal touches the bottom of the plastic (see visually). Screwing in the
opposite direction will create a bottom-up"clamping" effect which will hold the wire in place.
Screw terminal Clean Wires Bad Wires
Insert the wires to the VS1 input as shown, between the top bent metal and the bottom metal,
making sure the black wires goes to (-) and the red wires goes to (+). Tighten the screws to
ensure the wires are secure, and verify that there are no loose strands which may cause a short
circuit.
RobotShop Inc. 305-18005 Lapointe, Mirabel, Quebec, Canada, J7J0G2
21