Table of Contents
Advertisement
Step A9 : Install the base top using the horn screw from step A5. The hole pattern of the top
plate should line up with one row of holes pointing to the servo wire hole at the rear, and all of
the lines pointing between the mounting tabs. Note, this top piece is manufactured to be a tight
fit to the servo horn, so be sure to align them well and you might have to press hard.
Step A10 : Pass the servo's cable through the hole in the back of the base. This will keep the
base level to the mounting surface.
RobotShop Inc. 305-18005 Lapointe, Mirabel, Quebec, Canada, J7J0G2
11
Hide quick links:
Advertisement
Table of Contents
