Step A13 : Install the power plug wiring harness as shown (servo controller greyed out). To do
so, you need to remove the nuts and spacers which come installed on both the switch and
barrel connector. You can use a tie wrap or tape to hold the wires in place. The SSC-32U only
needs the one wiring harness.
Note that the On/Off switch has three pins, of which two have wires. When the switch points
towards these two connectors, electricity can flow. In the image below, the switch would be OFF.
Switch in the OFF position
RobotShop Inc. 305-18005 Lapointe, Mirabel, Quebec, Canada, J7J0G2
20