Lynxmotion AL5D-PLTW Manual page 10

Step A5 : The Hitec 485HB servo is shipped with its white plastic horn centered. If the horn is
rotated by accident, ensure it lines up like the image below. It should rotate 90 degrees CCW
and 90 degrees CW. Unscrew the black screw holding the horn in place and KEEP IT for step
A9). Note that this screw is very tight and the appropriate screwdriver (correct Phillips head) is
needed. Apply some downward pressure but do not strip the screw . If the servo horn was
rotated, re-center it as in the image below, then pull the white plastic horn straight off of the
servo.
Step A6 : Place the servo in the base as shown and screw it in using four #4 x ⅜" Phillips head
tapping screws included with the base rotate kit. Note that the holes are not tapped - the screws
need to be turned and pressed to force thread the plastic.
RobotShop Inc. 305-18005 Lapointe, Mirabel, Quebec, Canada, J7J0G2
9